chris gallo
11-26-2010, 07:30 PM
New inspector here and still learning some of the ins and out of the equipment.
I did a recent inspection where my gas meter confirmed what I already smelled at a property. It was an outside gas leak but the detector was picking it up on the inside as well. Long story short, I am glad it works so well but now it is not working properly anymore at all. Once I turn it on and try to get to the first indicator light it shoots straight to the top. I tested in several different areas to be sure it wasn't picking up anything from somewhere else but it does the same thing. I have to turn the knob about 1/3 and then it goes full on.
Anyone else have this issue in the past and a good solution?
General did say to send it up to them and they would check it out.
thanks,
chris
I did a recent inspection where my gas meter confirmed what I already smelled at a property. It was an outside gas leak but the detector was picking it up on the inside as well. Long story short, I am glad it works so well but now it is not working properly anymore at all. Once I turn it on and try to get to the first indicator light it shoots straight to the top. I tested in several different areas to be sure it wasn't picking up anything from somewhere else but it does the same thing. I have to turn the knob about 1/3 and then it goes full on.
Anyone else have this issue in the past and a good solution?
General did say to send it up to them and they would check it out.
thanks,
chris