PDA

View Full Version : sec protection?



John Arnold
05-27-2011, 01:53 PM
How can I tell if this is the proper kind of can for this application?

ken horak
05-27-2011, 02:07 PM
Seeing how that looks like the bottom of a tuna fish can I'd say it's not good
But then I'm sure you didn't need me to tell you that

Bruce Ramsey
05-27-2011, 02:30 PM
Are those ring shank or spiral twist nails? If they are spiral twist, they spin free electrons which can set up a negative force field causing the electricity to slow down at this point. The rubber backing of the duct tape may act as a damper to limit the effects of the spiral twist nails. I recommend applying exterior paint on the can bottom as a rust preventative measure.

John Arnold
05-27-2011, 03:19 PM
Are those ring shank or spiral twist nails? If they are spiral twist, they spin free electrons which can set up a negative force field causing the electricity to slow down at this point. The rubber backing of the duct tape may act as a damper to limit the effects of the spiral twist nails. I recommend applying exterior paint on the can bottom as a rust preventative measure.

See, now, that is the kind of in-depth information that makes IN so valuable to me.

Nick Ostrowski
05-27-2011, 03:30 PM
HA HA HA!!! That's too much!

I'd like to be there to just watch some of this stuff being "installed".

John Kogel
05-27-2011, 08:07 PM
Hammer or nailgun? I'd say a ballpeen hammer. :D

Corn Walker
05-28-2011, 05:59 AM
For increased safety you should probably write "UL" on it in sharpie. Otherwise everything looks good.