PDA

View Full Version : Electrical cable routing


brianmiller
08-17-2013, 04:44 AM
Two questions:

1) would the practically 90 degree bends be considered "excessive"?

2) would you be concerned about the decking adjacent to the cables. I was thinking if there was structural movement the cables could be pinched by the decking, or am I overthinking again. Note: The decking is locked into place (nailed down), and is within 6ft of the attic access opening.
Roland Miller
08-20-2013, 12:07 PM
Two questions:

1) would the practically 90 degree bends be considered "excessive"? Yes, These bends should not exceed 5 times the diameter or thickness of this cable.. This cable may have all had the insulation damaged by the 90 degree bends.

2) would you be concerned about the decking adjacent to the cables. I was thinking if there was structural movement the cables could be pinched by the decking, or am I overthinking again. Note: The decking is locked into place (nailed down), and is within 6ft of the attic access opening.I would not be concerned..