sill plate bolts

[Frank Jones]

Is this acceptable?

30931

[Bruce Ramsey]

Supposed to be 1/2" bolt. Looks smaller. Photos often distort sizes.

One washer is required. Mulitple washers are not a problem, just a waste of resources.

[Mark Reinmiller]

Makes me wonder why they needed all those washers. If the bolt was not threaded more than that then maybe it was not properly embedded. Does not look like a real anchor bolt. On the other hand, are we talking about one bolt or were many installed the same way.

[Jerry Peck]

Washers also look too small in diameter and too thin ... of course with that many stacked up, the thickness of a single washer may be a moot point.

The other points raised about bolt diameter and possible lack of proper minimum embedment are quite possible too.