Results 1 to 4 of 4
  1. #1
    Jeff Eastman's Avatar
    Jeff Eastman Guest

    Default Siding Interface with Chimney

    Last edited by Jeff Eastman; 12-19-2007 at 04:00 PM.
    Member Benefits1

  2. #2
    Join Date
    Mar 2007
    Location
    Columbus GA
    Posts
    3,747

    Default Re: Siding Interface with Chimney

    All I can think of is wood trim, 2x2 or 2x4.
    If any flashing is there it will be behind the siding.

    ' correct a wise man and you gain a friend... correct a fool and he'll bloody your nose'.

  3. #3
    Join Date
    Mar 2007
    Location
    Columbus GA
    Posts
    3,747

    Default Re: Siding Interface with Chimney

    "If there isn't any flashing between the hardiplank and the brick chimney (just caulk) wouldn't it just leak at some point?"

    Yes, and every time it's painted (at the least) it will need to be resealed. A chimney can, does, and will move different than the house, sometimes a little sometimes more. There is nothing wrong with using the RIGHT caulk when APPLIED PROPERLY.

    ' correct a wise man and you gain a friend... correct a fool and he'll bloody your nose'.

  4. #4
    Join Date
    Mar 2007
    Location
    Fletcher, NC
    Posts
    28,042

    Default Re: Siding Interface with Chimney

    Reviewing the James Hardie Hardieplank installation instructions shows that this detail is not addresses specifically, however, there is a detail which addresses 'similar' points of installation, that being "Clearances" "Maintain a minimum 2" clearance between James Hardie products and decks, paths, steps and driveways." "Figure 4".

    Figure 4 shows that 2" clearance to both the horizontal surface and the vertical surface on steps (i.e., treads AND risers).

    The riser (vertical) portion would be 'similar' to the vertical chimney, so, *in my opinion*, a trim should be installed between the Hardieplank and the chimney.

    Or, send the photo and an e-mail to James Hardie and get the answer from the horses mouth.

    Jerry Peck
    Construction/Litigation/Code Consultant - Retired
    www.AskCodeMan.com

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •