Results 1 to 7 of 7

Thread: Chimney type

  1. #1
    Jon mackay's Avatar
    Jon mackay Guest

    Default Chimney type

    Can anyone tell me what chimney type this is and if the exterior is the correct match for the type. It looks like the exterior has been partially replaced.
    I am also curious why they have a column supporting the chimney here, obviously the support needs to be removed but will this chimney fall down?

    Similar Threads:
    ***IMPORTANT*** You Need To Register To View Images ***IMPORTANT*** You Need To Register To View Images
    Member Benefits1

  2. #2
    mike huntzinger's Avatar
    mike huntzinger Guest

    Default Re: Chimney type

    Does this come from a wood stove or a gas fired appl.


  3. #3
    Join Date
    Mar 2007
    Location
    Tacoma, WA
    Posts
    20

    Default Re: Chimney type

    From the first pic, it sure looks like a typical flue pipe. What was it attached to?

    Rob Jones
    Washington State Licensed Home Inspector #256
    www.washingtonhomeinspector.biz

  4. #4
    Jon mackay's Avatar
    Jon mackay Guest

    Default Re: Chimney type

    It is attached to an oil fired furnace and there is also an LP water heater venting into it.


  5. #5
    Join Date
    Mar 2007
    Location
    Tacoma, WA
    Posts
    20

    Default Re: Chimney type

    That looks to be a typical flue with a creative flashing at the roof level.

    Rob Jones
    Washington State Licensed Home Inspector #256
    www.washingtonhomeinspector.biz

  6. #6
    Dave Wheeler's Avatar
    Dave Wheeler Guest

    Default Re: Chimney type

    a draft test must be taken while the unit is running. It should be no less than a negative 2 {-.o2 }


  7. #7
    Join Date
    Mar 2007
    Location
    Near Philly, Pa.
    Posts
    1,682

    Cool train wreck

    Call for a Level II: That factory chimney is re-using an old larger roof flashing that was caulked in tight so it doesn't ventilate. The first pic shows single walled connector improperly penetrating a combustible ceiling with some sort of trim ring instead of a listed support box for the factory chimney with a listed transition to single walled pipe and maintaining clearances to combustibles including that ceiling. The combustible post (18" clearance) is probably because some genius stacked factory chimney right on the ceiling, punched the hole for the single walled connector and called it a day. Fire and collapse hazard. You can be sure improper chimney support, clearances, and attic insulation shield. Must have two point stability on chimney and the contact point with the boot flashing does not count.

    No tape on pipe--blocks view for inspection and is not approved for that application. Any pics in the attic? That's where the real scary pics would be taken.

    Very short stack, which might not generate sufficient draft. Doesn't appear to meet 3/2/10.

    Is this common vent and connector sized for both appliances per the IRC? Pics of the rest of the connector and appliances?

    Keep the fire in the fireplace.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •