Thread: WH Vent strapped to WH

..............

Similar Threads:

• Power Vent Water Heater Vent
• Direct Vent Pipe Clearance to Combustibles - SLP and Direct Vent Pro
• Height of Vent Pipe from a Vent hood used in a Laboratory
• Single wall pipe to b-vent vent question
• Plastic power vent to metal vent at brick chimney

Originally Posted by RobertSmith

I'd say that it would not be an approved method...but I can't see the real harm in it.

Other than sheet meta screws won't support 30-40-50 gallons of water?

Sounds like a make-shift repair. Perhaps the original draft hood was defective and didn't hold in place.

As long as the hood's secure, there isn't any harm. The sheet metal screws in the top of the tank won't hurt anything.

I'm not sure to what Billy's referring when he questions whether sheet metal screws will hold lots of water?

Originally Posted by Randy Navarro

Sounds like a make-shift repair. Perhaps the original draft hood was defective and didn't hold in place.

As long as the hood's secure, there isn't any harm. The sheet metal screws in the top of the tank won't hurt anything.

I'm not sure to what Billy's referring when he questions whether sheet metal screws will hold lots of water?

Earthquake Straps (if that is required.) I was looking at drawing (straps connected to wall?)


If Not.