Results 1 to 5 of 5
Thread: Metal Roof - Standing Seam
-
02-06-2014, 03:11 PM #1
-
02-06-2014, 05:09 PM #2
Re: Metal Roof - Standing Seam
Not sure about "not allowed", but they shouldn't be needed on the standing seam parts. For the rake edge, I'm not getting a visual image of how else it would be fastened to the roof. If they used the typical "pro panel" screws with the rubber washer, I wouldn't be too concerned about it. I don't see it would be any different than the more typical metal panel roof.
Jim Robinson
New Mexico, USA
-
02-06-2014, 06:33 PM #3
Re: Metal Roof - Standing Seam
Are you sure it is a standing seam roof?
With screws into the top of the 'standing seams' is sounds more like you may be describing a ribbed roof panel or V-crimp roof panel.
As Jim said, the rake edge closure/flashing is typically secured with screws, some along the top only (they hook over cleats or clips along the side), some along the top and side, and I think I've even seen some fastened along the side (those hooked over cleats or clips along the top).
-
02-06-2014, 06:52 PM #4
Re: Metal Roof - Standing Seam
Any pictures
-
02-10-2014, 04:17 PM #5
Re: Metal Roof - Standing Seam
This is one form of standing seam with concealed fasteners.
The OP might have meant this as Jerry suggested.
Bookmarks