Hot tub Panel

[Jeff Eastman]

.......

Similar Threads:

• Diagran for 4 wire 240 V circuit at load-side panel ("sub panel").
• Remote panel board feed from main panel buss bar
• Defects at service panel & distribution panel?
• Electical Panel/Sub Panel Question
• Feed From Main Panel to Sub Panel

[Jerry Peck]

*IF* that ground lug is attached at the proper location in that enclosure, and it looks like it is not. There looks to be a raised dome with a flat top, most likely with a screw hole in the center of it, just to the right of the neutral terminal bar, this is where the ground terminal 'should be' (if I am seeing correctly) attached.

If that were the case, and *if* that ground terminal was rated for 2 equipment ground conductors, then okay - but - not all of those smaller single terminals are rated for 2 equipment ground conductors.

It would be better and safer to have just installed a multiple terminal lug in the correct location. That would also eliminate any questions raised by this installation.

[Mike Schulz]

Well they did say they wanted a "HOT" tub.