Results 1 to 6 of 6
-
10-21-2015, 01:34 PM #1
Replace Flex gas line with solid pipe in Fireplace
Hello, I recently had a survey conducted on my house in Illinois to sell it. The inspector came back with the flex gas line needs to be replaced with solid pipe stating 'this is not the acceptable standard installation'. I recently had a tenant move out who installed gas logs. It was originally a wood burning vented fireplace with a gas starter. What type of pipe can I replace the flex line with? Who can I call to have this issue corrected? I'm pretty sure there was solid pipe installed prior to the tenant installing the logs. Approximate cost?
Thank you,
Sue
phpphVTvzPM.jpg
Similar Threads:
-
10-21-2015, 11:32 PM #2
Re: Replace Flex gas line with solid pipe in Fireplace
try home depot...Screen Shot 2015-10-21 at 11.29.35 PM.jpg
Mazza Inspections and stuff...
https://mazzainspections.com
https://waterintrusionspecialist.com
-
10-22-2015, 05:04 AM #3
Re: Replace Flex gas line with solid pipe in Fireplace
Call a plumber. Not a tough job and should bee quick. Guess about $200 but that is location dependent. Tell them what you need.
Wood fireplace with gas starter converted to gas log insert using flexible line for connection. Need to change flex line to solid line. You might ask if it is required by your local code.
You will want to check the chimney as you are changing to gas from wood fired. But that should have been in the HI's report.
Last edited by Garry Sorrells; 10-22-2015 at 04:14 PM.
-
10-28-2015, 10:11 PM #4
Re: Replace Flex gas line with solid pipe in Fireplace
Gas flex is just fine if installed correctly
The inspector needs to get his job back at Taco Bell
- - - Updated - - -
Gas flex is just fine if installed correctly
The inspector needs to get his job back at Taco Bell
- - - Updated - - -
Gas flex is just fine if installed correctly
The inspector needs to get his job back at Taco Bell
-
10-29-2015, 07:12 PM #5
Re: Replace Flex gas line with solid pipe in Fireplace
Robert Young's Montreal Home Inspection Services Inc.
Call (514) 489-1887 or (514) 441-3732
Our Motto; Putting information where you need it most, "In your hands.”
-
11-01-2015, 10:12 PM #6
Re: Replace Flex gas line with solid pipe in Fireplace
Gas log lighter pipes must be piped with rigid steel pipe per CSA std. so the pipe cannot flop around. Remember, it is a burner pipe. The penetration must be properly chinked and caulked where it penetrates the sidewall of the appliance. It should have a throttling valve within reach of the fireplace for lighting and must have an approved shutoff within 6 ft. IFGC does have special allowance for remote shutoff on fireplaces if three conditions met: serves only that one appliance, ready access and properly labeled.
Gas logs can use approved flex connectors per their listing unless local codes specifically prohibit them.
Changing fuels triggers a Level II inspection per NFPA 211.
Keep the fire in the fireplace.
Bookmarks