Results 1 to 18 of 18
  1. #1
    John Stephenson's Avatar
    John Stephenson Guest

    Default Plumbing vent height

    Last edited by John Stephenson; 12-22-2007 at 08:12 AM. Reason: added photo of what vent looks like in attic
    Inspection Referral

  2. #2
    Join Date
    Mar 2007
    Location
    Columbus GA
    Posts
    3,747

    Default Re: Plumbing vent height

    Other that being a bird perch I don't think the height is a problem.
    It is to close to the valley.

    ' correct a wise man and you gain a friend... correct a fool and he'll bloody your nose'.

  3. #3
    Join Date
    Mar 2007
    Location
    Fletcher, NC
    Posts
    28,042

    Default Re: Plumbing vent height

    No, on roofs used for other than weather protection only, the vents are required to be 7 feet high above the roof.

    Jerry Peck
    Construction/Litigation/Code Consultant - Retired
    www.AskCodeMan.com

  4. #4
    Join Date
    Oct 2003
    Location
    Rockwall Texas
    Posts
    4,521

    Default Re: Plumbing vent height

    7 feet?


  5. #5
    Richard Rushing's Avatar
    Richard Rushing Guest

    Default Re: Plumbing vent height

    I think he forgot the 'smiley' after the bird-perch comment...




  6. #6
    David Banks's Avatar
    David Banks Guest

    Default Re: Plumbing vent height

    The plumbing code here in MA says minimum of 18 inches. Max 24 inches. So I do not think your height is an issue.
    Jerry 7 feet? Are you thinking of something else?


  7. #7
    Join Date
    Mar 2007
    Location
    Fletcher, NC
    Posts
    28,042

    Default Re: Plumbing vent height

    From the IRC (and other plumbing codes).
    - P3103.1 Roof extension. Open vent pipes that extend through a roof shall be terminated at least 6 inches (152 mm) above the roof or 6 inches (152 mm) above the anticipated snow accumulation, whichever is greater, except that where a roof is to be used for any purpose other than weather protection, the vent extension shall be run at least 7 feet (2134 mm)above the roof.

    That means that when there is mechanical equipment on the roof, sun decks, you name it, the plumbing vents need to extend up above the roof 7 feet. This is to get the terminal end above the peoples who will be using the roof for whatever reasons they are using the roof.

    IF the roof is used for "weather protection" only (not counting when someone goes up to do repairs or cleaning on the roof - the roof's purpose in those cases is still "weather protection") then the vent terminal must be at least 6" high above the roof, plus whatever additional height is required by the AHJ for snowloading so the vent is never buried in snow.


    Jerry Peck
    Construction/Litigation/Code Consultant - Retired
    www.AskCodeMan.com

  8. #8
    Join Date
    Mar 2007
    Location
    Corpus Christi, TX
    Posts
    615

    Default Re: Plumbing vent height

    Quote Originally Posted by Jerry Peck View Post
    From the IRC (and other plumbing codes).
    - P3103.1 .......IF the roof is used for "weather protection" only (not counting when someone goes up to do repairs or cleaning on the roof - the roof's purpose in those cases is still "weather protection") then the vent terminal must be at least 6" high above the roof, plus whatever additional height is required by the AHJ for snowloading so the vent is never buried in snow.
    Being a clutz, I wish that they hadn't made that exception.

    The only reason some people get lost in thought is because it's unfamiliar territory.
    - Paul Fix

  9. #9
    Join Date
    Mar 2007
    Location
    Healdsburg, CA
    Posts
    1,741

    Cool Re: Plumbing vent height

    Does this help?

    ***IMPORTANT*** You Need To Register To View Images ***IMPORTANT*** You Need To Register To View Images
    Jerry McCarthy
    Building Code/ Construction Consultant

  10. #10
    Tim Moreira's Avatar
    Tim Moreira Guest

    Default Re: Plumbing vent height

    Quote Originally Posted by John Stephenson View Post
    What problems are caused with a vent being this high?

    None...


  11. #11
    Join Date
    Mar 2007
    Location
    Fuquay Varina, NC
    Posts
    1,074

    Default Re: Plumbing vent height

    There is nothing wrong with that vent...........Your problem lies elsewhere.

    Mike Schulz License 393
    Affordable Home Inspections
    www.houseinspections.com

  12. #12
    Bob Stark's Avatar
    Bob Stark Guest

    Default Re: Plumbing vent height

    Well said, Jeff !


  13. #13
    David Banks's Avatar
    David Banks Guest

    Default Re: Plumbing vent height

    Quote Originally Posted by John Stephenson View Post
    What problems are caused with a vent being this high?
    John no one said 22 inches was wrong. But the reason in MA for 24 inch max is that in cold climates condensation can occur in tall vents and freeze therefor potentially closing the plumbing vent.


  14. #14
    Join Date
    Mar 2007
    Location
    Corpus Christi, TX
    Posts
    615

    Default Re: Plumbing vent height

    Quote Originally Posted by Jeff Eastman View Post
    John,

    "What Mike is eluding to, but being deliberately evasive for whatever reason, is that the base flashing skirt can not extend into the valley, can cause water intrusion."

    I don't agree with that. I read Mike's response as "the problem of the slow drain rate has an origin other than the vent height".

    "You can have a vent that height, HOWEVER, it may also indicate previous plumbing repairs for bad venting or drainage which I think is what you were driving at in your origional question that no one answered for you. Tell your client to consult with homeowner if there were any previous repairs. Did you see any problems with the drainage to tubs, sinks in that area?"

    What am I missing? All three questions were answered.

    I sure wish people would just answer questions directly, state why things are or are not a problem, and then just provide the proper recommendation. It would stop a lot of nonsense on this board
    Exchanges of ideas and interpretations of codes, manufacturer instructions, and generally accepted building practices is the PURPOSE of this board. This is not intended (at least I hope not) as a teacher/pupil format. It's one of those things where you have to cut through the pontificating and grandstanding sometimes, but it's a small price for the knowledge gained over time. Learning is a process, not a destination and sometimes you have to dig through the doo-doo to get to the pony.

    The only reason some people get lost in thought is because it's unfamiliar territory.
    - Paul Fix

  15. #15
    Join Date
    Mar 2007
    Location
    Fletcher, NC
    Posts
    28,042

    Default Re: Plumbing vent height

    Jerry M.,

    That drawing is for gas vents, this tread is regarding plumbing vents.

    Jerry Peck
    Construction/Litigation/Code Consultant - Retired
    www.AskCodeMan.com

  16. #16
    Join Date
    Mar 2007
    Location
    Fletcher, NC
    Posts
    28,042

    Default Re: Plumbing vent height

    Quote Originally Posted by Jeff Eastman View Post
    I sure wish people would just answer questions directly, state why things are or are not a problem, and then just provide the proper recommendation. It would stop a lot of nonsense on this board
    They have been.

    There are THREE (count them - 3) questions in that post, different people answered different questions. Nothing wrong with that.

    Jerry Peck
    Construction/Litigation/Code Consultant - Retired
    www.AskCodeMan.com

  17. #17
    Join Date
    Mar 2007
    Location
    Fuquay Varina, NC
    Posts
    1,074

    Default Re: Plumbing vent height

    Sorry I was in a hurry and shot a quick reply.

    (This vent was 22 inches high. Tub had slow drainage.)
    It could be a number of things but the height is not one of them such as blockage, undersized, a big hair ball in the tub drain


    (What are all the ramifications of having a vent this high?)
    As long as it's in the specified range as listed in some of the post, "none"

    (Could a vent this high impact the drainage of the tub?)
    Jerry or one of the other guru's probably answer this better but I don't think height is a question as far as drainage is concerned.


    (Also, would anyone say it is a problem with the base flashing for the vent over hanging the valley?)
    It would be nice for it to be further out of the valley so it don't collect debris and ice damming and large volumes of water but as long as it's installed correctly it shouldn't leak. Granted this may be the first area that may start leaking when the roof ages.

    Jeff, Please forgive for I have sinned and it won't happen again Not!

    Mike Schulz License 393
    Affordable Home Inspections
    www.houseinspections.com

  18. #18
    Frank Kunselman's Avatar
    Frank Kunselman Guest

    Default Re: Plumbing vent height

    John,

    Food for thought. The vent height is of no relevance to the drainability of the tub. As long as the vent diameter is at least 1/2 the diameter of the tub drain and not less than 1 1/4 inch diameter the vent can run 40 feet high...if you want it to stick 50 feet above the roof deck simply increase it to 1 1/2 inch diameter (one pipe size increase).

    A plugged vent could have some effect, but I would venture to guess a hairball downstream...they sure cause my tubs to drain slowly. Also, if the slope is too shallow, there is a loss of velocity which affects the rate of flow.

    Back to the plugged vent theory, slow drainage would be the least of the problems. Your trap would be sucked dry which would allow sewer gas to enter the bathroom (and you were blaming the smell on the kids, right).

    Some things you might want to investigate would be the distance from the trap wier to the vent, is the vent vertical off the drain or is it a horizontal dry vent. If it is correctly vented, you could always replumb the tub with 2" from the trap to the branch drain (leaving the 1 1/2" trap) or replumb with a greater slope.

    I hope this helps.


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •