Results 1 to 2 of 2
  1. #1
    Don Rataj's Avatar
    Don Rataj Guest

    Default Residential flat roof venting/flashing requirerments

    1) 2 story multi family with TJI roof joist (min flat slope) with drywall to the underside and batts insullation between the joist with modified bitumen roof.
    BOCA called this area between the joist and the flat roof an attic.
    Attics need to be vented but this area was not vented per the constrctuion drawings.
    Is the architect responsible for mold build up on the ceiling due to this enclosed space?

    2) Membrane roof (same building) installed pprior to pararpets being completed and flashing was installed with wide caulk joint (by possibility the masons latter) Acceptable? Roofer did not return to complete project.

    Similar Threads:
    Member Benefits1

  2. #2
    Join Date
    Mar 2007
    Location
    Fletcher, NC
    Posts
    28,032

    Default Re: Residential flat roof venting/flashing requirements

    Quote Originally Posted by Don Rataj View Post
    1) 2 story multi family with TJI roof joist (min flat slope) with drywall to the underside and batts insullation between the joist with modified bitumen roof.
    BOCA called this area between the joist and the flat roof an attic.
    Attics need to be vented but this area was not vented per the constrctuion drawings.
    That is an attic area, yes.

    Is the architect responsible for mold build up on the ceiling due to this enclosed space?
    It would probably cost more to try to hold the architect responsible than to address the problem. When were those units built?

    2) Membrane roof (same building) installed pprior to pararpets being completed ...
    That is not uncommon, as long as everything is done in the proper sequence with regard to the flashing of/to the parapet walls, which also depends on what the parapet walls are constructed of and what the cladding is.

    and flashing was installed with wide caulk joint (by possibility the masons latter) Acceptable? Roofer did not return to complete project.
    Not enough information to know, or really understand what you are describing. You may be describing the joint between flashing and counter flashing?

    Any photos?

    Photo of the approved drawing showing what was intended?

    The flat/low slope roof needs to have a minimum of 1/4" per foot slope.

    Jerry Peck
    Construction/Litigation/Code Consultant - Retired
    www.AskCodeMan.com

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •