Electrical panel

Wade Johnson · 06-23-2010, 01:54 AM

Good morning. What is happening when some of the breakers in a panel are warm or even hot to the touch?

Similar Threads:

**Jim Port** · 06-23-2010, 05:18 AM

Heat is generated by the current flowing through the breaker. This heat is what causes a breaker to trip on overload.

Abnormal levels of heat could point to a problem.

**Michael Thomas** · 06-23-2010, 07:13 AM

Were they AFCI breakers?

**Michael Thomas** · 06-23-2010, 07:14 AM

Originally Posted by Jim Port

Heat is generated by the current flowing through the breaker. This heat is what causes a breaker to trip on overload...

Well, at least in many modern designs, not exactly, see for example:

HowStuffWorks "Basic Circuit Breaker Design"

**Bill Kriegh** · 06-23-2010, 08:32 PM

Most all breakers of modern manufacture (that you're likely to find in a residence) have both a magnetic and thermal component to the trip mechanism.

An illustration that does not reflect actual trip curves but illustrates the point is a 15 AMP breaker may carry 16 Amps for many hours before tripping, but will trip much sooner with a 30 AMP load.

The magnetic component makes for instant tripping when a fault occurs.

Older breakers may lack the magnetic component

**Gunnar Alquist** · 06-23-2010, 08:49 PM

Originally Posted by Wade Johnson

Good morning. What is happening when some of the breakers in a panel are warm or even hot to the touch?

If there were lots of high intensity lights on for a long time, it might explain the problem. A Zinsco/Sylvania panel might be arcing at the buss bar connection. I would defer and have an electrical contractor look at it.