Results 1 to 14 of 14
  1. #1
    Join Date
    Jul 2010
    Location
    NC
    Posts
    122

    Default Unconventional truss system?

    Came across a truss system different from any other truss system I have seen. This system had no gusset plates where the truss system meets at the middle, and was slightly offset 1/2" very likely due to movement due to the age of the structure (41 years) with two boards directly under the truss.

    Please advise if this is an unconventional truss system, conventional for the early 70's or if it needs further review.

    Thank you,

    Sidney Alstad

    Similar Threads:
    ***IMPORTANT*** You Need To Register To View Images ***IMPORTANT*** You Need To Register To View Images
    Crawl Space Creeper

  2. #2
    Join Date
    Mar 2007
    Location
    Knoxville, TN
    Posts
    2,560

    Default Re: Unconventional truss system?

    Modular home????? Did you look at the top plate in the middle of the house to see if it was a modular?


  3. #3
    Join Date
    Feb 2009
    Location
    Southern Vancouver Island
    Posts
    4,607

    Default Re: Unconventional truss system?

    I thought the same thing, double-wide modular. I wouldn't be too concerned about that slight offset. If everything is straight and true up there, it was likely built that way.

    John Kogel, RHI, BC HI Lic #47455
    www.allsafehome.ca

  4. #4
    Join Date
    Jul 2010
    Location
    NC
    Posts
    122

    Default Re: Unconventional truss system?

    Quote Originally Posted by Jack Feldmann View Post
    Modular home????? Did you look at the top plate in the middle of the house to see if it was a modular?
    Top plate not visible due to 12" of blown insulation. Would you write this up as typical for modular framing and further investigation by a licensed general contractor and/or owner disclosure.


  5. #5
    Join Date
    Mar 2007
    Location
    Knoxville, TN
    Posts
    2,560

    Default Re: Unconventional truss system?

    I wouldn't write it up as modular construction unless you were sure it was. Did it have a crawlspace? A modular home would be detected in the crawlspace as well. Another clue is there will usually be a wall (in the center of the house, that is much wider than the others (because the two sections meet in the center).
    If I go up in an attic and see trusses like that, I will move the insulation at the center point and look at the top plate. But, like I said, its usually obvious when you go under the house.

    In Tennessee, it has to be disclosed if the house was not "site built". Many people don't have any idea (if they bought an older house, then sold it years later).

    You may want to see if you can get back in the house and verify. That way, you don't look like an idiot for calling out a modular when its not, and you can look "good" for calling one out when no one knew. If its a crawlspace, you may not even need to get back inside the house, just crawl under it and look at the center area.


  6. #6
    Join Date
    Jul 2010
    Location
    NC
    Posts
    122

    Default Re: Unconventional truss system?

    Quote Originally Posted by Jack Feldmann View Post
    I wouldn't write it up as modular construction unless you were sure it was. Did it have a crawlspace? A modular home would be detected in the crawlspace as well. Another clue is there will usually be a wall (in the center of the house, that is much wider than the others (because the two sections meet in the center).
    If I go up in an attic and see trusses like that, I will move the insulation at the center point and look at the top plate. But, like I said, its usually obvious when you go under the house.

    In Tennessee, it has to be disclosed if the house was not "site built". Many people don't have any idea (if they bought an older house, then sold it years later).

    You may want to see if you can get back in the house and verify. That way, you don't look like an idiot for calling out a modular when its not, and you can look "good" for calling one out when no one knew. If its a crawlspace, you may not even need to get back inside the house, just crawl under it and look at the center area.
    No, it did not have a crawlspace, but a walkout basement (finished).

    ***IMPORTANT*** You Need To Register To View Images ***IMPORTANT*** You Need To Register To View Images

  7. #7
    Join Date
    Mar 2007
    Location
    Knoxville, TN
    Posts
    2,560

    Default Re: Unconventional truss system?

    Looks like it could easily be a modular. Can you get back in?
    Looking at the attic photos again, it really looks like a modular.


  8. #8
    Join Date
    Jul 2010
    Location
    NC
    Posts
    122

    Default Re: Unconventional truss system?

    Quote Originally Posted by Jack Feldmann View Post
    Looks like it could easily be a modular. Can you get back in?
    Looking at the attic photos again, it really looks like a modular.
    Was thinking that it may be a tract home with a split truss system.

    Sidney Alstad


  9. #9
    Join Date
    Mar 2007
    Location
    Knoxville, TN
    Posts
    2,560

    Default Re: Unconventional truss system?

    You won't know for sure unless you look at it. Your call.


  10. #10
    Join Date
    Feb 2009
    Location
    Southern Vancouver Island
    Posts
    4,607

    Default Re: Unconventional truss system?

    Quote Originally Posted by sidney alstad View Post
    Was thinking that it may be a tract home with a split truss system.

    Sidney Alstad
    They put a lot of extra wood into that truss system. That ridge beam wouldn't even be there in a normal truss roof. The only logical reason would be to transport the home or the roof in two halves.

    There could be a building permit or whatever you call it at the municipal office. There should be documentation from when the place was built. The realtor could verify that for your client.

    John Kogel, RHI, BC HI Lic #47455
    www.allsafehome.ca

  11. #11
    Join Date
    Jun 2008
    Location
    Maryland
    Posts
    1,096

    Default Re: Unconventional truss system?

    Check out that gable vent from the exterior pic. Looks like it could be a split design too. One that comes together when they mate the two halves.


  12. #12
    Join Date
    Dec 2008
    Location
    Maryland
    Posts
    2,809

    Default Re: Unconventional truss system?

    If not modular then why the 3 series of 12p gal nail on both sides of the ridge?


  13. #13
    Join Date
    Jul 2008
    Location
    Snowbird (this means I'm retired and migrate between locations), FL/MI
    Posts
    4,086

    Default Re: Unconventional truss system?

    Quote Originally Posted by Garry Sorrells View Post
    If not modular then why the 3 series of 12p gal nail on both sides of the ridge?
    Overlay roofing.


    Pre-fab modular typical.

    Appears the "walkout" portion ("man door, windows) previously OH door, "basement" area expanded.

    Unkwn foundation/garage/basement original or dugout, retaining wall appearance, alterations, and lot topography from photo raises questions as to how many "generations" of alterations/remodels have taken place.


  14. #14
    Join Date
    Oct 2011
    Location
    Minneapolis, MN
    Posts
    780

    Default Re: Unconventional truss system?

    Quote Originally Posted by Garry Sorrells View Post
    If not modular then why the 3 series of 12p gal nail on both sides of the ridge?
    Those are just long roofing nails, I believe.

    What's holding the two sides together at the top? I don't see any attachment holding the ridge beam boards together. The offset could mean they are sliding - or it could mean nothing at all.

    Do not think of knocking out another person's brains because he differs in opinion from you. It would be as rational to knock yourself on the head because you differ from yourself ten years ago.
    - James Burgh, 1754.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •