Results 1 to 5 of 5
  1. #1
    Garry Blankenship's Avatar
    Garry Blankenship Guest

    Default Interesting DIY Electrical

    Very tight crawl and could not get as close as preferred. A cable I have not seen before. Gray jacketed, 12/3, stranded cu. Definitely not typical N/M, but similar construction. Interesting part is that terminal block used to splice, ( no j-box & no wire nuts ). The separated conduit is a garage/shop sub-feed. Also unique wire - - - #2 cu, but a very fine stranding. That same 12/3 stranded cable was used for the water heater circuit. Could not get enough label data off that cable to ID it. Reported all; but I give them high marks for creativity. Close to what is necessary, but a swing and a miss. Lots of similar "closes". The "one" kitchen counter circuit was fed through the first GFI outlet. The following two outlets were also GFI. The first tripped all and the 2nd & 3rd tripped themselves - - - double protection
    .

    Similar Threads:
    ***IMPORTANT*** You Need To Register To View Images ***IMPORTANT*** You Need To Register To View Images
    OREP Insurance

  2. #2
    Mark Kittle's Avatar
    Mark Kittle Guest

    Default Re: Interesting DIY Electrical

    Don't see an equipment ground in the cable. Looks like some kind of data or media cable and probably not recognized as a suitable wiring method in the NEC. Open splice in close proximity to the insulation, not good. What's up with the PVC???


  3. #3
    Join Date
    Mar 2008
    Location
    Charlotte NC
    Posts
    2,304

    Default Re: Interesting DIY Electrical

    Looks like power cord used in electronic equipment, main frame computers, printers, etc. Typicaly ran fans, small motors and power supplies.

    The beatings will continue until morale has improved. mgt.

  4. #4
    Join Date
    Feb 2009
    Location
    Southern Vancouver Island
    Posts
    4,607

    Default Re: Interesting DIY Electrical

    It could be low voltage wiring for speakers, computer or controls of some kind. Low voltage, then no j-box required.
    But since you saw the same wiring going to the water heater it is probably high voltage, NFG. It looks like extension cords.

    I saw an extension cord to water heater setup where there were frequent power failures. The HO could plug the WH into his generator during blackouts.

    Will a spark ignite that fiberglass insulation?

    Last edited by John Kogel; 07-31-2012 at 01:21 PM.
    John Kogel, RHI, BC HI Lic #47455
    www.allsafehome.ca

  5. #5
    Join Date
    Dec 2007
    Location
    Chico,Ca
    Posts
    454

    Default Re: Interesting DIY Electrical

    Flexible cord spliced on DIN rail mounted terminal blocks... More garbage "work".


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •